TKF-M Series Monoblock Pumps

Discharge Flange : DN 32 – DN 150
Capacity : 500 m³/h
Head : 100 m
Frequency : Three-phase 50 Hz – 60 Hz*
Temperature of Pumped Liquid : From -25 ˚C to+140 ˚C
Maximum Operating Pressure : 10 bar (16 bar)*


-Monoblock centrifugal pumps with horizontal shaft, volute casing, single stage, end suction and closed impeller.
-The main dimensions of the housing comply with EN 733 standards.
-Design according to EU 547/2012 energy rating.
-Suction and discharge flanges according to EN 1092 – 2 / PN 16. Flanges are suitable for EN 1092 – 1 / PN 16 in pumps with steel or stainless steel body material. Pumps could be produced with ANSI / ASME flanges optionally.
-Pumps are used with electric motors of high efficiency class according to IEC structure sizes.
-All impellers are balanced dynamically or statically according to ISO 1940 class 6.3.
-The axial force is balanced with the wheel balancing holes system.
-The direction of rotation is clockwise by the engine.
-Monoblock pumps are smaller and lighter than the same hydraulic centrifugal pumps.
-Optionally, pumps can be manufactured with wear ring and / or shaft bushings.
-The pump shaft is connected to the motor shaft with a plug-in shaft or rigid coupling. The axial and radial forces of the pump have covered by the motor bearings.


-Agricultural Irrigation and Drainage
-Building System
-Food and Beverage Industry
-Heating, Ventilating and Air Conditioning
-Water Treatment and Pressurization